The Bowflex Xtreme 2 SE Home Gym is a rod resistance based home gym that is also upgradable. Something that is not very common with most home gyms, be it weight stack or body weight resistance based system. It has the lowest resistance weight option of 5 pounds up to 105 pounds; this means 105 pounds on each side of the handle when multiplied by 2 it becomes 210 pounds which is the standard resistance weight.
These resistance rods are made of special composite material and sheathed with protective rubber coating.
This is how the resistance rods are arranged on each side of the arm, 5, 10, 10, 30, and 50 pounds. So you may decide to start off your work out with the minimum of 5 pounds or with 10 pounds or even combine the 5 and 10 together to get a 15-pound resistance effect depending on your preference and fitness level. And you might as well go all the way and combine the whole 5 rods that will amount to 105 pounds.
The Bowflex Xtreme 2 SE Home gym offers over 70 exercises for a full body workout for the chest, shoulder, back, arm, abdominal, and leg. This is a complete and impressive home gym for home use which will certainly fulfill your overall workout needs and this, not a hype but a fact.
It is easy and convenient to use because you don’t even have the need to change the cable pulley system in order to engage in different exercise. Once it is fully assembled all you need to do is to work out and adjust the resistance level when necessary and which is also pretty easy and quick to do.
And just so you know, this home gym made it to our best home gyms review.
Frame and Design
The Bowflex Xtreme 2 SE is a well built and quality home gym that is made to be sturdy. The frame made of steel tubing finished with anti-corrosion and scratch resistant paint that would prevent rusts or scratches and thereby preserve its original look. However, this home gym is not outdoor equipment but meant to be used indoors.
This home gym supports maximum users’ weight of 300 pounds and capable of accommodating users of different and all sizes.
It will require a bit of workout space of 8 feet by 6 feet 5 inches to fully accommodate the entire unit including other parts such as the resistance rods that are spread to the sides. Otherwise, this is a rather compact machine with a footprint of 53 inches long by 49 inches wide, but with the resistance, rods included its dimensions will be 96 inches long by 78 inches wide. Also, the height of the home gym is 83 inches, which is pretty tall. So, a room with at least 7 feet 5 inches will be required so that the unit can fit and conveniently be used.
It weighs about 184 pounds which is not too heavy when compared to other home gyms that have stack weight resistance system such as the Body Solid Strength Tech EXM2500S or the Powerline BSG10X Home Gym, but enough to improve the stability of the unit though.
It is also equipped with a seat and backrest that is well padded with 2 inches of polyurethane cushioning for optimal comfort and covered with faux leather upholstery. The seat is also adjustable with 6 positions to conveniently accommodate users of all sizes. However, the backrest is non-adjustable.
The seat has a locking pin that secures and fastens the seat bottom bracket to the seat support rail. The purpose of the locking pin is to stabilize the seat for all exercises that requires sitting or leaning on it.
Therefore, it will be wise to always make sure that the seat is secured properly before using or putting weight on it or attaching the power rod to cables attached to the leg extension attachment.
There are only three words to describe the seat and the backrest and that is ‘’comfortable and durable’’.
The home gym is not meant to be moved around as it does not even have any transport wheels available. And to protect your floor from being damaged by the base and the weight of the machine it is advisable to place it on a rubberized mat.
The Pulleys and Cables
The Bowflex Xtreme 2 SE Home Gym has high quality and durable pulleys that are made of nylon material. It also features stainless steel ball bearings that are designed to swivel up to 360 degrees in order to allow a user to perform workouts without restrictions.
The home gym comes with adjustable ‘’slider’’ pulleys which can be personalized for your body. You can do so by adjusting them to widths that suit your unique physique. These slider pulleys are located on the lat tower (2 positions per side), on the center cross bars (4 positions per side), and the squat pulley frame (4 positions per side).
When performing standard exercises you will have to determine which pulley positions are most suitable and comfortable for you. You can simply adjust the pulleys outward or inward to perform exercises in ‘’wide’’ or ‘’narrow’’ positions.
What the adjustment of the slider pulleys to ‘’wide or narrow’’ positions for exercises do is to improve the possibility of targeting different parts of the same muscle group and increase the positive outcome of each exercise.
Did we mention that you don’t have to change the cable pulley system in order to perform different exercises? Yes, we did!
This is an impressive edge on the part of the home gym because most home gyms require a change of cable before performing different workout which could momentarily disrupt the exercise momentum and the heart rate level. The Bowflex Xpress has several sets of cables for various different types of exercises that do not require a swap of the cable by the user in order to engage in a different exercise. Basically, all that will be required of the user is to work out all the way and perhaps adjust the resistance levels when there is the need.
The cables that come with the unit are made of high-quality steel material that is covered with a very thin rubber coating for smooth operation over the pulleys and have been tested for over 1,000 pounds of resistance.
There are 3 distinct workout stations available in Bowflex Xtreme 2 SE Home Gym but each of the workout stations is multi-functional and these are the high pulley station, mid pulley station, and the low pulley station.
There are six different pulley positions that are used to perform a full workout routine and these are as follows;
Center Cross Bar
This is a standard position that is used when a user wishes to perform exercises such as the bench press or chest fly.
This is basically used for exercises such as the pulldowns and pushdowns
For leg extension and the active pulleys are on the squat pulley frame
For squat and the active pulleys are on the squat pulley frame and on the center cross bar.
Abdominal Crunch Position
For abdominal crunches and the active pulleys are on the lat tower
The active pulleys are on squat pulley frame.
For further information with illustrations, you may download or read the owner’s manual right here.
Weight Resistance System
The Bowflex Xtreme 2 SE Home Gym features a power rod resistance system that uses elastic rods to generate resistance.
You cannot use free weights or dumbbells to increase resistance; it simply doesn’t have that option. But fortunately, its resistance is upgradeable.
Just like aforementioned, the resistance rods are made from a special composite material that is sheathed in a protective black rubber coating. And each rod is marked with the weight rating on the rod cap so that a user can simply identify the weight level of each rod and subsequently decide on which ones to use.
The standard weight resistance maximum capacity is 210 pounds while it can be upgraded to 310 or 410 pounds which are optional.
There are 5 resistance rods on each side of the machine meant for each hand. On each side of the resistance, rods are 5 pounds, 10 pounds, 10 pounds, 30 pounds and 50 pounds rods which if combined will make a total of 105 pounds resistance weight for each hand when multiplied by 2 it gives the standard weight of 210 pounds.
It is easy to either increase or decreases the resistance level. This can easily be done by connecting just a single rod of any capacity of 5, 10, 30, or 50 pounds or you can connect several rods of different resistance levels together to give you the preferred resistance level.
For instance, you can connect or hoop up the cable to the closest rods together through the rod cap and then still hook up the next closest rod on the same cable hook.
If you opt for the 310 or 410 resistance upgrade you will receive additional 1 or 2 pairs of 50 pounds rods.
For safety, when hooking up the resistance rods to the cable hooks, do not stand directly over the tops of the rods, instead, stand off to one side when connecting and disconnecting the power rod resistance from the cables to prevent getting hurt in case it snaps.
It is recommended to disconnect the cables from the power rods when you are not using the home gym and also bind the cables and power rods with the rod binding strap. Also, make sure that you remove the binding strap whenever you wish to use them again.
Hand Grips and Straps
The handgrips can be attached to wrist, ankle, or instep and attach the grips to the cables by snapping the cable clip onto the D-ring.
The standard grip is when you grasp the handle and the cuff together to form a grip without inserting your hand through the cuff portion. This is commonly used in most exercises such as the hammer grip exercises when you need to hold the hand grip vertically for greater wrist support.
Hand Cuff Grip
The handcuff grip is when you slip your hand through the cuff so that the foam pad rests on the back of your hand. Then hold the remainder of the grip that is sitting in your palm. This type of gripping is mainly used for exercises such as the front shoulder raises.
Ankle Cuff Grip
This is meant to fit the ankle and it is adjustable to fit all different size of ankles. Simply insert your foot or ankle and tighten the grip by sliding the handle back toward the cuff.
Abdominal Crunch Shoulder Harness
The harness needs to be hooked up on both ends with hooks onto the D-rings and then place the harness on your shoulders letting the handles hang over your chest and then grab the two handles.
Arch Cuff Grip
This is designed to fit securely over the arch of your foot. You can do so by simply inserting you’re your foot through the cuff until it is around the arch of your instep, then tighten the cuff around your heel to secure the grip.
The approval rating of the Bowflex Xtreme 2 SE Home Gym is very impressive and with a lot of positive feedback from actual users.
This is an indication that this home gym is recommendable and has the value for the price.
If you wish to purchase any product online, first check out the approval rating and see what the previous users are saying about it that way you will be able to form your own opinion as to whether to buy or not.
You may click right here to read the customers’ reviews on Amazon.
- Triceps Pushdown w/ Hand Grips
- Triceps Hammer Pushdown
- Triceps Pushdown w/ Lat Pulldown Bar
- Single Arm Pushdown
- Triceps Extension
- Cross Triceps Extension
- Hammer Triceps Extension
- “Rope” Pushdowns
- Seated Biceps Curl
- Standing Biceps Curl
- Concentration Biceps curl
- Hammer Biceps Curl
- Barbell Biceps Curl
- Reverse Barbell Biceps Curl
- Seated Hammer Biceps Curl
- Reverse Curl
- Triceps Kickback
- Hammer Triceps Kickback
- Arm Opposition Push-pull
- Upper Body Opposition Push-pull
- Wrist Extension
- Wrist Curl
- Resisted Dip
- Crossover Rear Delt Rows
- Crossover High Rear Delt Rows
- Reverse Fly
- Crossover Reverse Fly
- Seated Shoulder Press
- Front Shoulder Raise
- Shoulder Extension
- Shoulder Shrug
- Scapular Protraction
- Scapular Depression
- Lateral Shoulder Raise
- Seated Forearm Lateral Shoulder Raise
- Shoulder Rotator Cuff (internal)
- Shoulder Rotator Cuff (external)
- Crossover Seated Rear Delt Rows
- Scapular Retraction
- Leg Extension
- Calf Raise
- Single Leg Calf Raise
- Standing Hip Extension (knee bent)
- Standing Hip Extension (knee extended)
- Standing Hip Abduction
- Standing Hip Adduction
- Leg Kickback
- Hip Flexion
- Dead Lift
- Stiff Leg Dead Lift
- Standing Low Back Extension
- Bent Rear Delt Row
- Crossover Bent Rear Delt Row
- Seated Wide Lat Pulldowns
- Narrow Pulldowns w/ Lat Pulldown Bar
- Narrow Pulldowns w/ Hand Grips
- Reverse Grip Pulldowns
- Crossover Wide Pulldowns
- Crossover Narrow Pulldowns
- Stiff Arm Pulldowns
- Standing Shoulder Pullover w/ Hand Grips
- Crossover Seated Lat Rows
- Seated Lat Rows
- Reverse Grip Pulldown with Lat Bar
- Bench Press
- Chest Fly
- Decline Bench Press
- Incline Bench Press
- Decline Chest Fly
- Incline Chest Fly
- Seated (resisted) Abdominal Crunch
- Seated (resisted) Oblique Abdominal Crunch
- Trunk Rotation
- A very sturdy and high-quality home gym
- The frame is made of steel tubing
- The power rods are made of composite material that could make last long
- The resistance is upgradeable to 310 or 410 pounds
- Has a standard resistance of 210 pounds
- Has a very solid, well-padded seat that can be secured for a safe and comfortable workout. It is also adjustable
- Has over 70 exercises available
- Quiet operation
- The pulleys are made of heavy-duty materials with stainless steel ball bearings
- No cables require changing when you wish to perform a different exercise
- Supports up to 300 pounds maximum user weight capacity
- It has multiple grip handles
- Assembly is not complicated
- The resistance rods lose elasticity over a period of time of use, and that means that the resistance will drop below what it suppose to be.
Product Dimensions and Specifications
- 53’’ Length
- 49’’ Width
- 83’’ Height
- 96’’ Length (Workout area)
- 78’’ Width (workout area)
- 83’’ Height (workout area)
- Supports up to 300 pounds maximum user weight capacity
- Over 70 exercises available
- Power Rod Resistance System
- 210-pound standard resistance
- 1 Year on Frame
- Lifetime on Power Rods
- 60 Days on Parts
Shipping, Assembly, and Maintenance
The shipping cost of the Bowflex Xtreme 2 SE Home Gym depends on the retailer you are buying from, however, Amazon usually provides free shipping and delivers in 3 to 4 days. They are well packaged in the box.
To assemble this home gym is not really difficult because it is pretty straightforward with an instruction manual that will walk you through the assembly process.
It comes with a couple of tools but you will definitely require your own personal tools to completely assemble the unit. Tools such as the adjustable wrenches and screwdrivers will be needed.
Depending on how good you are at working with your hands it will take anywhere from 3 to 5 hours to fully assemble.
Just as aforementioned, you should always unhook the cables off the power rods when you are not using the home gym and strap up the power rods and the cables together with the strap that comes with it.
Also, make sure to remove the strap from the power rods when you are ready to the machine again.
Then, another thing is the normal cleaning of the home gym from dust and sweat at all times.
The Bowflex Xtreme 2 SE Home Gym is one of the best power rod resistance system home gyms that you can rely on to provide full body workouts.
It has all the necessary features to help you realize your fitness goals.
If you have any questions please feel free to ask and we shall be glad to respond accordingly.